B22's 34g neo nano

B

b22

Premium Member
Starting up a new DSA neo nano 34
[attachment=0]ImageUploadedByTapatalk1357437457.377392.jpg[/attachment]
 
Equipment will be
Radion gen2
MP10W
Reef keeper lite
Bubble-magus NAC 5.5
Eheim 1250
 
[attachment=1]ImageUploadedByTapatalk1357437950.735971.jpg[/attachment]
[attachment=0]ImageUploadedByTapatalk1357437972.053405.jpg[/attachment]
 
You might consider putting a "T" coming out of the bulkhead for the drain lines and then creating a durso to keep the drain noise down. On our Neo Nano it was almost unbearable!
 
[attachment=0]ImageUploadedByTapatalk1357442851.199423.jpg[/attachment]
Started to add water and sand.
 
@niteowl
BTW I am using a very small pump (Eheim 1250) only 317gph. So I don't think it will be pushing enough water to make much noise.
What return pump did you use?
 
I was running a Mag 3 pump at about 2.5-3ft of head height so probably about 250gph. There wasnt enough air to water mix to stop the gurgling noise.
 
[attachment=0]ImageUploadedByTapatalk1357452370.059754.jpg[/attachment]
Skimmer neck has a leak and will be going back :(
 
Tank is full of water with no leaks so far.
Niteowl you are right it is a little loud. Hope it gets a little quiet after break in.
 
Rock should be in next week from BRS
Reef keeper and hang kit for radion should be here Monday.
 
[attachment=0]ImageUploadedByTapatalk1357612721.539137.jpg[/attachment]
What a PTA but I got the radion hanging. Time to work on the reef keeper.
 
Looking good. I also had a neo nano and went with some type of durso like majig. Helped a TON

Samsung Galaxy S III
 
You must log in or register to reply here.
Top