Recent content by monisa

Here's what's left, please make any reasonable offers ;) 2. Refractometer on right $10 3. HMM Dual TDS meter 2. has never been used $25 5. 40Gal Brute with heater and pump for mixing saltwater. $40 2x American DJ plugs mounted on stained plywood $20

2x American DJ plugs mounted on stained plywood $20

1. BRS refractometer with calibration solution $15 2. Refractometer on right $10 3. HMM Dual TDS meter 2. has never been used $25 4. BRS 75gpd RODI + TDS Built in + comes with “seperate” new set of filters and 1/2 bag DI changing resin + 40Gal Brute collection bin + built...

Please text 972-804-6191

Anyone has some,  near Plano, can do curbside pickup?

Anyone has some,  near Plano, can do curbside pickup?

$20 frag, generous sizes.$50 multi branch colony sizes.PS: Frags are unmounted Call or Text 972-804-6191Address is 6400 Bronze Leaf Dr, Plano 75023.

$20 frag, generous sizes.$50 multi branch colony sizes.PS: Frags are unmounted Call or Text 972-804-6191Address is 6400 Bronze Leaf Dr, Plano 75023.

1 SML RBTA  $203 MED RBTA $25 each2 LRG SHROOMS $2 each2 GREEN PALLY FRAGS $5 each1 NEON GREEN NEPTHIA 9inch Tall Multi Branch $601 PULSING SINULARIA $20 Frag up to $50 for Multi Branch Text or Call  if you interested 972-804-6191

1 Platinum Clown @ $303 Large RBTA's @ $50 eachText me @ 972-804-6191

1.       200+Lb Live rock2.       Fish(Yllw Tang, 2 Clowns, 2 Chromis, 2 Lyretails, 1SixLine, Brittle star, Shrimp, hermits)3.       Corals mainly softies various + 4 Red Bubble Tip Nems.4.       3 Sets of LEDS with manual dimmable switch5.       2 MP 40’s W, upgraded to Quiet Drive.6.      ...

After replacing every filter, di and membrane I still get a high tds reading of 140. I checked my asov and lines going through all the stations and all is fine. After reading melevs posts on trouble shooting rodi units, I find my check valve can be blown through both ways, should be one way...

I have my Bio-Pellets in a dual BRS reactor, One side only, slightly less than half full. I used the "Plastic Mesh" from Hobby Lobby and cut it out and placed it in the inside container. Top and Bottom. It runs good for around a week or so and then stops tumbling. Anyone has the same issue on...

One of bulbs switched off. After checking all wiring, bulb flickers but does not turn on. Switched to a new ballast, the same problem, changed bulbs and the same problem. Any suggestions on what maybe the problem?

After cleaning my skimmer pump, I placed it back into the water and connected everything back to the skimmer and turned it on. I needed to adjust the level, so I reached in to adjust the rising pipe and got a terrible "shock", [smilie=sweating.gif] I left it on to see if any of that...