[I finally got the motivation to hook up my skimmer, took 2 trips to Home Depot, worked out all the plumming leaks, and noticed that there's a slow leak in the skimmer itself.
First, is that normal?
Second, is it fixable?
Third, if fixable, how?
The leak is inbetween the top part of the black section and the plastic part that is not detachable (IE: not the very top cup part that is removable).
I also noticed that the water level never went higher than the top part of the non-removable section. Is this normal? I would have thought the water level would have to get quite a bit higher in order to put any "skim" in the cup part. Its also possible that it didnt get very high because I tested my setup in a blue tub full of clean salt-water so would not have any skim to skim out. The skimmer did seem to airate or agitate the water ok enough.
Other info - I had a maxi-jet 900 hooked up to it with about 2 feet of plastic tubing going to the input part and nothing attached to the output tubing.
Thanks.]
First, is that normal?
Second, is it fixable?
Third, if fixable, how?
The leak is inbetween the top part of the black section and the plastic part that is not detachable (IE: not the very top cup part that is removable).
I also noticed that the water level never went higher than the top part of the non-removable section. Is this normal? I would have thought the water level would have to get quite a bit higher in order to put any "skim" in the cup part. Its also possible that it didnt get very high because I tested my setup in a blue tub full of clean salt-water so would not have any skim to skim out. The skimmer did seem to airate or agitate the water ok enough.
Other info - I had a maxi-jet 900 hooked up to it with about 2 feet of plastic tubing going to the input part and nothing attached to the output tubing.
Thanks.]