Best way to frag a frogspawn

L

landon_brim

Just like the title states, I am looking to frag several heads off of my frogspawn. Some of the heads on top have been overshadowing the bottom heads. What is the best way to frag the ones on bottom? Should I just snap them off with a pair of pliers or another type of tool? Help! I was hoping to do this before they just shrivel up to nothing without light.
Thanks.
 
If you have access to one, I used a Dremel tool to start the cut, then bone cutters to finish it...

If possible, remove the entire colony from the tank. With LPS, you wanna remove it from it's spot, then hold it upside down for a few seconds to "frighten" the polyps so that they'll retract to avoid injury to them as you remove it from the water. I then cut the heads as low on the branch as I could with the dremel, then just snapped 'em the rest of the way off with the bone cutters...
 
http://reefkeeping.com/issues/2006-11/fotm/index.php

reef central just did a fraggin write up on frogspawn
 
I guess it would be inappropriate to get in line for frag in this forum, huh?

Well, just thought I'd ask. :D

Curtis
 
while Serk's method works and is much more elegant.......

you can just grab your friendly chisel and hammer and go to town. you may end up with more frags than planned if not careful though.
 
You must log in or register to reply here.
Top