the other thread was getting too long so i thought i would show some new pics here. I finally got my controller hooked up and the tunze multi-controller hooked up, the litermeter hooked up and the triggersystems 300 skimmer hooked up. Things to do....
1. hook up the PM kalkwasser reactor...need help with this one
2. figure out how module 2 of the liter meter runs the kalkwasser reactor
3. replace conductivity probe with new one (have it, just have not put it in)
4. replace iwaki close loop pump with dart pump
5. add about a 35g acrylic top off container
6. make new probe holders for the sump
7. make close loop plumbing work with my water change plan...hope it works.
enjoy - feed back +/- is always appreciated...still learning the best way to do things!
1. hook up the PM kalkwasser reactor...need help with this one
2. figure out how module 2 of the liter meter runs the kalkwasser reactor
3. replace conductivity probe with new one (have it, just have not put it in)
4. replace iwaki close loop pump with dart pump
5. add about a 35g acrylic top off container
6. make new probe holders for the sump
7. make close loop plumbing work with my water change plan...hope it works.
enjoy - feed back +/- is always appreciated...still learning the best way to do things!