So I re-did my sump recently and I'm having a little problem that I haven't encountered before. The sump now has the skimmer and ca reactor on the right side, then 2 baffles, and then the return section where my gen-x pump pulls water out of the sump and returns it to the display.
For some reason, the drains on the display cause a bit of a 'rocking' motion in the return section of the sump. Not sure what is causing this, could be the skimmer, could be the 1" drop from the last baffle into the return section, but it is reaking havoc on my top-off. The float switch in the return section goes up and down, up and down, etc. This turns the PH on/off constantly. I tried to install a small section of eggcrate b/w the baffles, which helped a little, but I need a more permenant solution. I'll snap a few pictures to help out with the descriptions.
Anyone got any ideas?
Thanks,
Chris
For some reason, the drains on the display cause a bit of a 'rocking' motion in the return section of the sump. Not sure what is causing this, could be the skimmer, could be the 1" drop from the last baffle into the return section, but it is reaking havoc on my top-off. The float switch in the return section goes up and down, up and down, etc. This turns the PH on/off constantly. I tried to install a small section of eggcrate b/w the baffles, which helped a little, but I need a more permenant solution. I'll snap a few pictures to help out with the descriptions.
Anyone got any ideas?
Thanks,
Chris