New goodies! - Where to put them in system?

J

JeepTJ

[Okay, so I should be getting some new goodies today. The stuff I'm not 100% sure about where to put would be:

1 - Two little fishies phospate reactor 150, with some phosban, hooked up to a MJ 400.

2 - Pinpoint PH monitor

I have a 75g RR tank, but I'm assuming these items should go down in the sump/fuge. For that, I have an ecosystem pro 3616. The first section (skimmer) is pretty cramped with the skimmer, the drain from the tank+micron bad and 2 heaters. The fuge section has the thermometers for the heaters, and two lights above it that are on 24/7 (and of ocurse, some cheato). The last section has my ehiem 1262 return pump and a grounding probe. It's only got about a 6 gallon capacity in this section, and I get about 2 gallons of evap a day (which means I have to top off every day - no room in stand for auto top-off).

So - where/how should I put my new toys in the system?]
 
[Cool! Was worried the reactor thing would take some some valuable real estate, so I guess I'll only need to make room for the powerhead to drive it - that should be easy.

The PH probe - does it matter if it's in fast moving, slow moving, high light, low light water?]
 
[The amount of flow/light level shouldn't matter on the probe placement. So long as it's in a place where it will always be in the water, you're in good shape.]
 
You must log in or register to reply here.
Top