Milwaukee sms122 - How to setup?

[Carabelli]

[hi -

i have a new sms 122 ph controller and i can't figure out how to set the cutoff point for the calcium reactor solenoid?? does anyone have any experience with these that i could bounce some questions off of?? thanks.

gm

oh, i did email milwaukee instruments and i am waiting for a reply.]

 

[melev]

[If you have the same one I have on my 280g, you'll put the probe in a container that the effluent drips into. Set your controller to 7.0 for now, and then if all goes well after a few weeks, you can move it down to 6.8

That is the setting I use. The effluent drips about 1 to 2 drops per second in the cup, and the cup overflows quietly into my refugium section.

You never got my PM regarding this?]