Search results

Well. I am ion the bandwagon now. I have read tons of stuff online. So, couple of questions. 1 do any of you start off with a Lower salinity? 2 do any dip the fish before putting it in the QT? If so what and how? 3. Do you start any other treatments at all once you put them in? Or just wait to...

Well I took a few years off. Back in now. There was no Bio Pellets when I left. Pros and Cons of each for a 30Gal Nuvo? I dont know what route I want to take Thanks

Anyone know where I can find a 1/4 in Check Valve? Had one that went bad.

Does anyone carry these? I need a replacement as I broke mine trying to fix it. Thanks CW

Ok. I watched something wierd right before lights out. I noticed my tank getting cloudy and went to take a look at it. Every single one of my Chestnet Turbos were either releasing Eggs or Sperm into the water. This happened for about 45 minutes. The craziest thing I have seen to date in my...

I run a BM 250 on my 210. I love it. Mesh can be a pain in the butt to restart sometimes. Otherwise it is a beast.

Any A/C guys near the plano area to help recharge a chiller?

Anyone ever recharge their own chillers? I have an aqualogic that uses r-134a Thanks Chad

Ok. One of my overflows is draining alot slower than the other. Any suggestions on how to even out the flow between the two?

Ok. This is very general. If a skimmer is overflowing. Is it usually because the Sump level is too high or too low? Cant remember which way it goes. Thanks

Ok, I am sure this has been asked hundreds of times. How do you use your PH Probe for your CA Reactor. Also, how do you us the PH Controller to control the CO2? My thoughts are to set it up in the tank and have it shut off the CO2 if PH gets lower that 8. Thanks

Ok. I am planning out my new 215. What is everyones oponion on Chiilers? Who makes the best? Also which ones are the quietest. JBJ Aqualogic Teco Pacific Imports Thanks! Chad

Purchased 2 Maxima Clams and noticed both have small tears in the mantles. These are my first clams. They seem healthy and open up fully and respond to the hand of the light. I need sugestions cause I dont know what to do.

My CBB I had for over 2 months somehow got caught in my new Vortech. Doesnt look like he is going to make it. But he is trying to hold on. Anyways. Who in town carries those covers I seen that goes over the pumps? Has anyone else using vortechs had any issues with their fish getting caught in...

Had a 1 week old Midas that decieded he wanted to jump. I have a canapy that is only opened on the back side of the take. Any one have any suggestions for covering? I would like to do something other than glass for the obvious reasons of heat. Any other suggestions to keep fish from jumping out...

I have a couple of white looking tubes with an Anenome think coming from the end of them. Seems to be growing on a peice of LR I have. Any idea of what it might be? I dont have a picture to post of it. I have searched and have yet to find any pictures of them. Any help would be great

I need to pick up a 1/4 faucet adaptor. Anyone know who might carry those? Thanks, Chad

Is it ok to add some salt to my Top off to slowly raise up my SA level? I am a little low at 1.02 and I am running LSP/SPS. Thks

Anyone using this controller? What are your oponions on them? Thanks

Have a new Euro Reef 135 rs. It has been running about 4 hours now and I can not get the mirco bubbles from escaping in the outflow. Any suggestions on how to tune it in? Thanks!!